Calcite Presoak - Remove Calcite from Clay Brick
EaCo Chem Calcite Presoak - 1 Gallon
Removes Calcite on Clay Brick (Only!)
Calcite Presoak is designed as a pre-soak to facilitate the removal of calcite on clay brick (USE ON CLAY BRICK ONLY). Used in conjunction with NMD 80, this combination will ensure the complete removal of calcite.
First apply the Calcite Presoak undiluted and allow it to dwell on the surface for approximately five minutes. Repeat this process without rinsing until little pin holes have opened up. Then apply NMD 80 diluted four parts water to one part solution (4:1) without rinsing off the Calcite Presoak; allow a five to ten minute dwell time. Rinse completely to get the desired results.
For Use On: Clay brick
Use to Remove: Calcite
Product Details
- Powerfully penetrates and softens calcite
- Coverage rates will vary based on severity of calcite build-up. Proper testing will determine actual coverage rate.
Dilutions
Calcite presoak is always used undiluted
Pre-Testing
Always test prior to beginning full-scale cleaning operations. Pre-testing will determine suitability and effectiveness on each type of surface and stain designated to be cleaned. Pre-testing will also determine dwell times and number of applications required to achieve desired results. Pre-testing will show any potential or adverse reactions to adjacent surfaces. Allow test areas to thoroughly dry before evaluating final appearance and results
Safety Information
Always wear goggles and chemical resistant gloves when handling this product. Read the Safety Data Sheet for additional safety and health hazard information prior to use
Questions & Answers
Have a Question?
Be the first to ask a question about this.