OLD LABEL Historic Pointing Mortar - Moderate Strength, Coarse - Quart
You're in luck! We are updating all labels for our in-house packaged products. Take 50% off these 'old label' quarts.
Historic Pointing Mortar - Moderate Strength Coarse - 1 Quart
-
Historic Pointing Mortar - Moderate Strength, Coarse
Histocal® Traditional Masonry And Grouting Mortar MG II, Coarse
Pre-Blended NHL based mortars - Just add water.
For applications and mortar joints over 1/4 inch wide.
Technical Data
Product Brochure
2.75lb
Water Consumptionapprox. 4.5 l each bag
CompositionHISTOCAL® Historic Masonry and Grouting Mortar MG II (coarse) consists of natural hydraulic lime NHL 5 acc. to EN 459-1, pozzolan and grain-classified crushed lime sands.
Properties- Free of cement
- Grading curve according to historic findings
- High natural water retention properties
- Very good side adhesion
- Highly permeable
- Low-tension hardening process
- Low E-module - high elasticity
For laying bricks and grouting of historic masonry (e.g. natural stones, bricks). We recommend our HISTOCAL® Historic Masonry- and Grouting Mortar MG IIa in case of buildings subjected to humidity.
SubstrateThe substrate must be dry, clean and free from loosely attached particles. Sufficiently wet absorbing masonry before.
ProcessingTo be processed with all commonly used mortar mixers (continuous mixer, gravity mixer, blunger) and by hand. Watch for uniform and correct consistency (well earth-moist to plastic).
After-treatmentProtect fresh mortar until sufficient hardening (usually several weeks) against premature drying-out through sun radiation and draft (e.g. hinge with jute sheets kept moist or spray with mist nozzles). The mortar must be protected against frost for several weeks until sufficient hardening has been achieved!
Special notesThe air and surface temperature must be at least 5 ° C and maximum 25 ° C. HISTOCAL® Historic Masonry and Grouting Mortar MG II (coarse) shall only be used in the original state without additives.
StorageDry, if possible on wooden shelves and protected against draft.
Technical data- Grain size: 0-4.5 mm
- Solid mortar raw density: approx.1.75 kg/dm³
- Compressive strength 28 days: approx. 3 N/mm²
- Flexural strength 28 days: approx. 1.0 N/mm²
- E-Module: approx. 3.5 kN/mm²
Mortal will react very alkaline with water, thus: Protect skin and eyes, rinse thoroughly with water in case of contact, immediately contact doctor in case of eye contact.
Quality-monitored productionHISTOCAL® Historic Masonry and Grouting Mortar MG II (coarse) is continuously tested in our plant laboratory with respect to the fulfilment of composition and properties. This will ensure a uniform quality of the product. HISTOCAL® Historic Masonry and Grouting Mortar MG II (coarse) is certified acc. to EN 998-2.